Spray on Dirt for Camouflage

Spray on Dirt for Camouflage Super Sticky spray dirt or soil simulation coating or wash conditions outside the paint is necessary to protect our troops in combat. It can be used to finance aircraft, helicopters and humvees. Sounds like a good idea, right? But how to get the sticky dirt on vehicles, such as camouflage? Well there are different ideas about this. Hudson sprayer, aerosol cans, pressure washers in line with the nozzles for water injection or a truck. Each of these forms of work may not in reality. Of course, we must eliminate the aerosol spray idea, which could be good for model airplanes, but they are always to make a single vehicle. Hudson, using a sprayer or small air compressor like sprayer could also work, but still time conducive.A is in line with the injection pressure washer can work and use only minimal amounts of water and could Humvee in a layer of about 3-5 minutes per side, maybe we could go down to 2-3 minutes, which would be acceptable. The spray should be used about 2 liters per minute and apply the sticky stuff. Sand camouflage simply spray on the sticky material and then have a fan to blow dust and sand on board the vehicle. Or look for a green bar issue should match the color and went at once with water. The camouflage paint should not be soluble in water as if it rains all the camouflage of security is blown. Since the solution and the paint is not soluble in water, which is to be able to be removed easily by another method, as the vehicles move from one place to another in the camouflage should be amended to keep the vehicle convoy of Soldiers and security. "Lance Winslow" - Online Think Tank forum. If you have innovative ideas and unique perspectives, we think with Lance;